Hand control | Radio control | Radio remote control | waterproof
Prices incl. VAT plus shipping costs
Ready to ship today,
Delivery time appr. 1-3 workdays **
Everything under control!
Our hand control guarantees safe and uncomplicated maneuvering of your water sports equipment. Since it is waterproof, "dives" are no problem anymore. The included cuff works like a swimming tire so htat the remote control floats on the water surface and can easily be picked up again.
The features at glance:
This colt steering with it´s LCD display not only shows how much % of power is currently used but also how much battery power is left (receiver needs to be connected to battery). Unwanted paddeling to the shore is history now. In addition, this control has a Cruise Control for permanent desired speed.
- Hand control
- Y- cable
- USB cable
- Charging pad
- Circuit diagram
- Cuff to prevent sinking of the controller
Installation of the controller:
1. Connect the input cable of the BEC parallel with the controller (red to red / black to black)
2. Connect triple plug of the BEC to one of the sockets of the Y-cable (the red/black flat plug cable of the BEC is for programming only and therefore not required)
3. Connect the second jack of the Y-cable to the controller
4. Connect the plug of the Y-cable to the jack of the receiver
5. Secure the receiver protected in your water sports equipment. An antenna output to the surface is not required
Usage of controller:
1. zutn on the transmitter by pressing the button on the left side 3 seconds
2. Connect battery to ESC
3. You can hear a short beep followed by 3 more beeps now
4. Pull gas until you hear 3 tones with increasing sound
5. The controller is ready to use now
Charging the hand control:
1. Connect the charging pad using the suuplied USB cable and your PC
2. Place the hand control at the center of the charging pad
3. The display lights up and shows current state of charging level now
If you have any questions regarding your watersports project our MHZ team will help you anytime.
> Do you have any questions concerning this product?
|Material:||ABS plastic black|
|Sensor Type:||Hall sensor|
|Size:||152 x 24mm|
|Display:||25,6 x 16,6mm|
|Display shows:||control mode, remote batt. voltage, receiver detection voltage, signal strength, PWM signal %|
|Full charge working time:||More than 2 hours|
|Transmission distance:||Air: 10m, Water: 1m|
|Throttle signal output:||1-2ms 50Hz PWM 5V max.|
|Voltage range:||5-75V +/- 5%|
Ordered and payed until 10am (European time) sent same-day. No minimum order quantity. Check shippment costs here.
We do accept payment by paypal and bank transfer. Credit card payment through paypal is also accepted.
Queries? Please contact us anytime by using our contact form.